Assembly is in the reverse order, bearing in mind the following: |
–
| Check the disengagement collar for wear and, if necessary, replace it. |
–
| If necessary check the centring of the clutch drive plate. |
–
| Apply a thin layer of -G 000 100- to the disengagement collar, the guide sleeve for the collar and the primary shaft spline. |
–
| Make sure that the engine unit centring bushings are correctly fitted and, if necessary, fit them. |
–
| Bolt the rear engine and gearbox support to the engine unit. |
–
| When fitting the engine unit check that there is sufficient play with the half shafts. |
Note! When fitting the engine unit on vehicles with ABS, be especially careful not to damage the ABS unit lines. |
|
|
|