–
| Remove the oil pressure switch -F1- and screw it into the tester. |
–
| Screw the tester into the engine block, in the oil pressure switch's location. |
–
| Connect the brown tester cable to earth (-). |
–
| Attach the diode lamp -V.A.G. 1527 B- with the auxiliary cables -V.A.G. 1594 A- to battery positive (+) and to the oil pressure switch. The diode must not light. |
–
| If the diode lights, renew the 0.9 bar oil pressure switch -F1-. |
If the diode does not light: |
–
| Start the engine and gradually increase engine speed. Between 0.75 ... 1.05 bar overpressure the diode should light, to the contrary, renew the 0.9 bar oil pressure switch. |
–
| Continue increasing engine speed. At 2,000/min and being at a temperature of 80 °C, the oil pressure should be at least 2.0 bar. |
|
|
|