seat Workshop Repair Guides

SEAT Leon Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Technical data

Removing and positioning the diesel engine in the Leon Mk1

Attaching engine to repair stand
Attaching engine to repair stand
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Special tools and workshop equipment required
t  counterhold -T20127-, see equivalent → Anchor
t  base -T20172/1-, see equivalent → Anchor
t  Tower -T20172/2-, see equivalent → Anchor
t  Engine bracket -T20172/3-, see equivalent → Anchor
t  Workshop crane

Requirements:
l  The gearbox must be removed from the engine
Operation process
  Note
To align the assembly centre fit the counterhold -T20127- to the anchorage points as shown in the figure.
   
–  Hook the support tool -T20127- on the engine and on the workshop crane, as shown in the illustration.
  DANGER!
Ensure that the hooks are closed with the security rings.
–  Raise the engine from the counterhold -T20205- lifting it using the workshop crane and lower it.
  Note
If operations are planned for the crankshaft or sealing flanges, the flywheel and intermediate plate must be removed before fixing to the engine bracket -T20172/3-.
–  Place the engine support -T20172/3- carefully on the engine, and then fasten it on the base -T20172/1- together with the tower -T20172/2-.
  E10-0109

Enginecrankshaft group, pistons > < Technical data