seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Crankshaft: disassembly and assembly > < Insert the sealing flange with the sender wheel

Leon Mk1

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
t  Removing → Anchor
t  Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  4 mm wrench -T10370-
t  or conventional Socket SW 5 with ball head
  Note
Two different screws are fitted that the tool has to be used to check.
Removing
  W00-10582
–  Release the fasteners -arrows- to remove the central soundproofing panel.
–  Disconnect and remove the coolant hoses using the hose clip on the radiator.
–  Remove oil filter bracket → Chapter.
–  Remove the connector of the engine speed sender -G28-.
  E10-0086
–  Unscrew the fixing bolt -2- with the 4 mm wrench -T10370-.
–  Remove the engine speed sender -G28--1-.
Fitting
Installation is carried out in the reverse order, noting the following:
Tightening torque of fixing screws of the engine speed sender -G28-: 5 Nm
  A23-0209

Crankshaft: disassembly and assembly > < Insert the sealing flange with the sender wheel