seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Conversion table by relevance > < Checking glow plug system

Leon Mk1

Glow plugs: verification
Glow plugs: verification
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Auxiliary cable kit -VAG 1594C-, see equivalent → Anchor
  W00-10008
t  Spanner -U 40082-, see equivalent → Anchor
  W00-2238
t  Voltage tester -VAG 1527B-, see equivalent → Anchor
Test prerequisites
l  Battery voltage at least 11.5 V
l  Ignition off
Checking sequence
–  Unplug connectors from glow plugs.
  W00-0513
–  Connect the cable from the diode to the (+) positive battery terminal using the pincers from the auxiliary measurement set.
–  Apply the testing point of the diode to each glow plug, one by one.
Diode lights up: Glow plug okay
Diode does not light up: Replace glow plug
–  Fit the glow plugs using spanner -U 40082- to 15 Nm.
  N28-0185

Conversion table by relevance > < Checking glow plug system