Leon Mk1
| Crankshaft - exploded view |
| 1 - | Bearing cap |
| q | For half-bearings 1, 2, 4 and 5 |
| q | Do not interchange used bearing shells (mark). |
| 2 - | 65 Nm and then turn 90° further |
| q | Replace |
| q | For measuring radial clearance, tighten to 65 Nm but do not turn any further |
| 3 - | Bearing cap |
| q | Bearing cap 1: Pulley side: |
| q | Bearing cap 3 with rebates for the thrust washer |
| q | Bearing shell retaining lugs in cylinder block and bearing caps must align. |
| 4 - | Thrust washer |
| q | For bearing cap 3. |
| q | Note fixing arrangement. |
| 5 - | Needle bearing |
| q | Vehicles with dual clutch gearbox only. |
| q | removing and fitting → Chapter |
| 6 - | Crankshaft |
| q | New axial play: 0.07 ... 0.17 mm Wear limit: 0.37 mm |
| q | Check radial clearance with Plastigage |
| q | new: 0.03 - 0.08 mm Wear limit: 0.17 mm |
| q | Do not rotate the crankshaft when checking the radial clearance |
| q | Crankshaft dimensions → Chapter |
| 7 - | Thrust washer |
| q | For cylinder block, bearing 3. |
