seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Conversion table by relevance > < General notes and safety precautions

Leon Mk1

Removing and installing ignition coils with output stages
Removing and installing ignition coils with output stages
t  Removing → Anchor
t  Installing → Anchor
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Extractor -T40039-, see equivalent → Anchor
Removing
–  Remove engine cover.
–  Unscrew two bolts on connector rail.
  W00-1303
–  Pull all ignition coils approx. 30 mm out of the spark plug holes using the extractor -T40039-.
–  Release connectors and unplug all connectors from the ignition coils at the same time.
Installing
–  Fit all ignition coils loosely into spark plug holes.
  N28-10011
–  Align the ignition coils with the connectors and attach all connectors onto ignition coils simultaneously.
–  Press ignition coils onto spark plugs by hand with uniform pressure (do not use tool).
  N28-10012

Conversion table by relevance > < General notes and safety precautions