seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Turbocharger: Installation Overview; Vehicles with Engine BWA . > < General diagram of exhaust gas turbo-charger, engine code BWA.

Leon Mk1

Intercooler: remove and install , engine identification letters BWA
Intercooler: remove and install , engine identification letters BWA
Removing → Anchor
Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Pliers for spring-type clips -VAS 6499- or Pliers -T20174-, see equivalent → Anchor
Removing
–  Remove the radiator → Chapter.
–  Remove the front bumper cover → Exterior body installation work; Rep. Gr.63.
–  Place lock carrier into original position: → Bodywork, exterior fitting work; Rep. Gr.50.
  Note
In order to avoid damage to the condenser or the pipes/hoses of the refrigerant, avoid pulling, bending or twisting excessively.
  WARNING
The air conditioning cooling circuit must not be opened.
  W00-10700
–  Undo the bolts -1- from the lock carrier plate to the intercooler.
–  Tilt the upper edge of the intercooler slightly backward.
–  Unmount between the cooler on the lower fixings. They raise the intermediate cooler.
–  Move the intercooler in the direction of the engine.
–  Support the lower side of the intercooler to prevent it from falling.
  A19-0474
–  Screw out bolts -arrows-.
–  Release the intercooler by lifting upward and removing downwards.
Fitting
Installation is carried out in the reverse sequence; note the following:
l  Tightening torques → Chapter.
–  Assembly of hose connections with couplings → Chapter.
–  Fill up coolant → Chapter.
  A19-10274

Turbocharger: Installation Overview; Vehicles with Engine BWA . > < General diagram of exhaust gas turbo-charger, engine code BWA.