seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Pistons and conrods: dismantling and assembling > < Crankshaft dimensions

Leon Mk1

Flywheel: Removing and installing
Flywheel: Removing and installing
t  Removing → Anchor
t  Installing → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Hose clamp -3067-, see equivalent → Anchor
  W00-0026
Removing
l  Gearbox removed.
–  Remove the lock plate of the clutch → Rep. gr.30.
–  Attach the counterhold tool -3067- before loosening bolts.
–  Remove bolts and take off flywheel.
Installing
Installation is carried out in the reverse sequence; note the following:
–  Tightening torques → Chapter
  Note
t  Replace the bolts tightened using goniometrics.
t  Installation is only possible at one position through the off-set arrangement of the boreholes.
–  Move counter-hold -3067- to tighten the bolts.
–  Install the lock plate of the clutch → Rep. gr.30.
  A13-10520

Pistons and conrods: dismantling and assembling > < Crankshaft dimensions