Leon Mk1
Note
|
1 - | Ignition cable |
q | 4 ... 8 kΩ |
q | With suppression connector and spark plug connector |
q | Check for continuity |
q | Disconnect the spark plug hood off with extractor -T10112- . |
2 - | Ignition transformer -N152- |
q | Fitting location → Item |
q | With markings for the ignition cables: |
t | A = cylinder 1 |
t | B = cylinder 2 |
t | C = cylinder 3 |
t | D = cylinder 4 |
3 - | 10 Nm |
4 - | Electrical connector |
q | Four-pin |
q | for ignition transformer -N152- |
5 - | Spark plug, 25 Nm |
q | Type and spark gap → Chapter |
q | To remove and install pull off the plug connectors for the outer injectors |
q | Remove and install with key -T20175- |
6 - | Double plug |
q | For the knock sensor I -G61- |
q | Gold plated contacts |
7 - | 20 Nm |
q | Tightening torque affects the functioning of the knock sensor I -G61- |
8 - | Knock sensor I -G61- |
q | Gold plated contacts |
q | Fitting location → Item |
9 - | 10 Nm |
10 - | Hall sender -G40- |
q | Gold plated contacts |
q | Fitting location → Item |
q | For removing and installing the throttle valve module -J338- |
11 - | Electrical connector |
q | for Hall sender -G40- |
q | Gold plated contacts |
12 - | O ring |