SEAT Workshop Service and Repair Manuals

Removing and installing radiator fan -V7- and radiator fan 2 -V177-   Note The procedure is identical for vehicles where only the radiator fan -V7- is fitted.

Removal: –  Unscrew air duct at lock carrier -arrows- and remove the air ducts. –  Remove the soundproofing → Bodywork, exterior fitting work; Rep. gr.50.

–  Pull off the air duct hose -arrow- underneath at the pre-volume container and remove it. –  Loosen the bottom coolant hose from the radiator.

–  Disconnect the plug -1- and unscrew the bottom fixing screws of the air duct -arrows-.

–  Unscrew the top fixing screws of the air conduit guard -arrows- and take out the air conduit guard to the top.

–  Disconnect the electrical connection -1-, and set the cables aside. –  Unscrew nuts -arrows- and take radiators out. Installing Installation is carried out in the reverse order; noting the following in the process: –  Fit the air conduit guard from above. Tightening torques:

Component	Nm
Radiator fan to air vent	10
Air vent to radiator	5