Leon Mk1
|
1 - | 23 Nm |
q | Insert with locking fluid. |
2 - | Camshaft wheels |
3 - | 100 Nm |
q | Use counterhold -3415- to loosen and tighten |
4 - | 10 Nm |
q | Insert with locking fluid. |
5 - | Rear notched belt guard |
6 - | Woodruff key |
7 - | Seal |
q | Renew |
8 - | 10 Nm |
9 - | Breather connection |
10 - | Special bolt - 9 Nm |
q | Renew if damaged or leaking. |
11 - | Seal |
q | Renew if damaged or leaking. |
12 - | Sealing plug |
13 - | Cylinder head cover: |
q | Loosen the screws from the outside to the inside for removal. |
q | Tighten the screws from the inside to the outside for fitting. |
14 - | Cylinder head cover gasket |
q | Renew if damaged or leaking. |
q | Insert the spacer sleeves → Item |
15 - | Cylinder head bolt |
q | Renew |
q | Observe sequence when loosening and tightening → Chapter. |
16 - | 10 Nm |
17 - | Hall sender -G40- |
18 - | O ring |
q | Renew |
19 - | Cylinder head |
q | Removing → Chapter |
q | Check for deformations → Chapter |
q | Reworking dimensions → Fig. |
q | Installing → Chapter |
q | Renew coolant after replacing cylinder head gasket |
20 - | Joint mouth |
21 - | 10 Nm |
22 - | O ring |
q | Renew |
23 - | Cylinder head gasket |
q | Fitting position: The component No. should point toward the cylinder head and be legible from the intake side. |
q | Renew coolant after replacing cylinder head gasket |