Leon Mk1
| Part I oil pump |
| 1 - | 15 Nm |
| 2 - | Retainer |
| q | Wiring harness for the oil level and oil temperature sender -G266- |
| 3 - | Dip stick |
| q | The oil level should not be over the MAX mark! |
| q | Marks → Fig. |
| 4 - | Filling funnel |
| 5 - | Guide pipe |
| 6 - | Dowel sleeves |
| 7 - | O ring |
| q | Renew |
| 8 - | 15 Nm |
| 9 - | Oil suction pipe |
| q | Clean strainer if dirty |
| 10 - | Oil deflector |
| 11 - | 15 Nm |
| 12 - | 15 Nm |
| 13 - | Oil pan |
| q | Clean sealing surface before installing |
| q | Install with silicone sealant -D 176 404 A2- → Chapter. |
| 14 - | Seal |
| q | Rolled onto the oil drain plug |
| 15 - | Oil drain plug, 30 Nm |
| q | Screw with seal that cannot be lost |
| 16 - | 10 Nm |
| 17 - | Oil level/oil temperature sender -G266- |
| q | Check → Vehicle diagnostic, testing and information system VAS 5051„function and component selection mode“ |
| 18 - | Seal |
| q | Renew |
| 19 - | Oil pump: |
| q | With pressure relief valve 12 bar |
| q | Before installing, check that the two dowel sleeves for centering oil pump/cylinder block are fitted. |
| q | Replace if there is scoring on the friction surfaces or the gear teeth. |
| q | Removing and installing → Chapter |
| 20 - | Pinions |
| 21 - | 20 Nm + 90° |
| q | Renew |
| 22 - | Chain for oil pump |
| 23 - | Sealing flange |
| q | Removing and installing → Chapter |
| q | Install with silicone sealant -D 176 404 A2-. |
| q | Replace crankshaft oil seal - pulley side. → Chapter |
| 24 - | Chain tension device with tensor rail, 15 Nm |
| q | Pre-tension spring and engage before installing |
