Leon Mk1
Active carbon filter system: removing and fitting |
1 - | Breather pipe |
q | Check for secure seating |
q | For the solenoid valve 1 of the active carbon filter -N80- (in the engine compartment) |
2 - | Pressure regulation valve with flexible junction tube |
q | Check for secure seating |
q | Comes from the pressure retention valve of the fuel tank |
3 - | Breather inlet |
q | Visible from below |
4 - | 10 Nm |
5 - | Throttle valve control unit |
q | With intake opening |
6 - | Solenoid valve 1 for activated charcoal filter -N80- |
q | On right in engine compartment |
q | Valve closed with ignition switched off |
q | When the engine is warm the valve will be activated from the engine control unit (pulsed) |
7 - | Connector |
q | Black, 2-pin |
8 - | Active carbon filter system |
q | Location: in the rear right hand side wheel housing |
q | To remove: |
q | Remove the rear right hand side wheel |
q | Remove the wheel housing protection |
q | Extract the tubes → Item and → Item |
q | Remove the bolt → Item and extract the deposit from underneath |