Leon Mk1
Crankshaft - Components overview |
1 - | Bearing shell |
q | For cylinder block with oil groove. |
q | Do not interchange used bearing shells (mark). |
2 - | Pinions |
q | For drive chain for oil pump |
q | replace → Chapter |
3 - | Bearing shell |
q | For bearing cap without oil groove. |
q | Do not interchange used bearing shells (mark). |
4 - | Thrust washers |
q | For bearing 3. |
q | Different version for the engine block and bearing cap |
q | Note attachment |
5 - | 65 Nm + 90° (1/4 turn) further |
q | Replace. |
q | To measure the crankshaft radial play, tighten to 65 Nm, but not more |
6 - | Bearing caps |
q | Bearing cap 1: Pulley side: |
q | Bearing cap 3 with rebates for the thrust washer |
q | The retaining tabs for the engine half-bearings/bearing cap must be on the same side as the bearing |
7 - | Crankshaft |
q | In vehicles with DSG gearbox, there should be a gear needle bearing fitted on the crankshaft. Fit it if necessary → Chapter. |
q | New axial play: 0.07... 0.17 mm; Wear limit: 0.37 mm |
q | Check radial clearance with Plastigage |
q | New radial play: 0,03 ... 0.08 mm; wear out limit: 0.17 mm |
q | When measuring the radial play, do not rotate the crankshaft |
q | Crankshaft dimensions → Chapter. |