Leon Mk1
Intake manifold: disassembly and assembly |
Engines AQQ, AUB |
1 - | Throttle valve drive -J338-* |
q | Test → Chapter |
q | In the event of replacement, adapt the engine control unit → Chapter |
q | Connector with gold contacts |
q | Without pulley for accelerator drive cable, since it is an electronic accelerator |
q | 6-pin connector |
2 - | 10 Nm |
3 - | Seal |
q | Replace |
4 - | Intake hole |
5 - | Gasket |
q | Replace |
6 - | Connecting line |
7 - | 10 Nm |
8 - | Ring gasket |
q | Replace |
9 - | Guide plate |
q | Check the fitting position |
q | Replace if worn |
10 - | O-ring |
q | Replace if worn |
11 - | 3 Nm |
12 - | Intake manifold pressure sender -G71-* with intake air temperature sender -G42-* |
q | Test the intake manifold pressure sender → Chapter |
q | Test the intake air temperature sender → Chapter |
q | Resistance values for intake air temperature sender between contacts 1 and 2 → Fig. |
q | Connector with gold contacts |
13 - | Intake manifold |
q | Removing and fitting → Chapter , Injection system components: removing and fitting |
14 - | Vacuum hose |
q | Comes from fuel pressure regulator → Item |
15 - | 20 Nm |