–
| Cut off tube nozzle at forward marking (nozzle approx.:). Approx. 3 mm) |
–
| Apply silicone sealing compound, as shown, to clean sump sealing surface. Sealing compound bead must be: |
t
| and apply to inside of bolt holes -arrows-. |
Note! The sealing compound bead must not be thicker, otherwise excessive sealing compound will enter the sump and may block the oil suction pipe strainer. |
–
| Install sump immediately and tighten all sump bolts lightly. |
–
| Tighten sump bolts to 15 Nm |
Note! t
| After installing sump the sealant must be allowed to dry for approx. 30 minutes before engine oil is filled. |
t
| The rest of the assembly is basically a reverse of the dismantling sequence. |
|
|
|