Leon Mk1
Exhaust manifold, front exhaust pipe and catalytic converter with attachments (engine codes AQQ, AUB) |
1 - | Warm air collector plate |
2 - | 10 Nm |
q | Note tightening sequence → Fig. |
3 - | Lambda probe 1 before catalytic converter -G39-*, 50 Nm |
q | Only grease threads with -G 052 112 A3-. -G 052 112 A3- must not get into the slots on the probe body |
q | If sealing ring is leaking nip open and replace seal |
q | Checking Lambda probe regulation: → Chapter |
q | Remove and install with open ring spanner -U-40080- |
4 - | Exhaust manifold with precatalyst |
5 - | Gasket |
q | Renew |
q | Note fitting position |
6 - | 25 Nm |
q | Renew |
7 - | Lambda probe 2 after catalytic converter -G130-*, 50 Nm |
q | Only grease threads with -G 052 112 A3-. -G 052 112 A3- must not get into the slots on the probe body |
q | If sealing ring is leaking nip open and replace seal |
q | Checking Lambda probe regulation: → Chapter |
q | Remove and install with open ring spanner -U-40080- |
8 - | To front silencer |
9 - | Marking |
q | Three times on circumference |
q | S = Manual gearbox A = Auto. gearbox |
10 - | Front exhaust pipe |
11 - | Front exhaust pipe |
12 - | Mounting |
q | Renew if damaged |
13 - | Flexible pipe |
14 - | 40 Nm |
q | Renew |
15 - | Gasket |
q | Renew |
16 - | 10 Nm |
17 - | Washer |
18 - | Support |
|