Indicated on display: (1...4 = Display fields) |
–
| Observe -8 digit number block- in display zone 4: (The right-hand 4 digits are of no consequence) |
Display in operating mode: |
2. With throttle valve closed, 2nd position from left must display 1 Display: 01000000 |
3. 3rd position from left must display 1 Display: 00100000 |
–
| Briefly open throttle fully (throttle burst). |
4. The 4th digit from the left must display 1 briefly Display: 00010000 |
Note! t
| A test drive may have to be performed to show “Full throttle” in display. |
t
| A 2nd person is required when performing a test drive. |
Caution Secure fault reader to rear seat and operate from this position. |
|
Observe the valid safety precautions when carrying out a road test → Chapter. |
–
| Increase engine speed to above 3000 RPM. |
–
| Close throttle valve abruptly. |
1. As long as the engine speed is above 1400 rpm, 1st position from left must display 1 Display: 11000000 (briefly) |
Note! Below 1400 rpm idling speed is again recognised. |
–
| Press keys 0 and 6 for the “End output” function and confirm input with the Q key. |
If the specifications are not attained: |
–
| Check accelerator mechanism for ease of operation. |
–
| Check throttle valve potentiometer → Chapter, throttle valve control part. checking: |
|
|
Read measured value block 4 → | |
|