Leon Mk1
Fitting locations overview |
Removing and installing cover over camshaft housing removal and installation → Fig. |
Air cleaner: removal and installation → Fig. |
1 - | Fuel pressure regulator |
2 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42- |
3 - | Intake manifold |
q | Dismantling and assembling → Chapter |
4 - | Injectors -N30-...-N33-) |
5 - | 4CV control unit -J448- |
q | Fitting location: In plenum chamber |
6 - | Knock sensor 1 -G61- |
q | Fitting location: cylinder block intake side |
q | → Item |
7 - | Throttle valve control part -J338- |
8 - | Earth connection |
q | Fitting location: In plenum chamber |
9 - | Engine speed sender -G28- |
q | Fitting location: cylinder block intake side |
10 - | 3-pin connector |
q | Black |
q | For engine speed sender -G28- |
11 - | Ignition transformer -N152- |
q | With ignition cable identification, do not interchange |
q | → Item |
12 - | 4-pin connector |
q | Black |
q | For Lambda probe and Lambda probe heating |
13 - | Coolant temperature sender -G62- |
q | With coolant temperature gauge sender -G2- |
q | For engine control unit |
q | If necessary release pressure in cooling system before removing |
14 - | Hall sender -G40- |
q | → Item |
15 - | Lambda probe -G39-, 50 Nm |
q | Fitting location: In front exhaust pipe |
q | Only lubricate thread with -G 052 112 A3-. -G 052 112 A3- must not get into the slots on the probe body |
q | If sealing ring is leaking nip open and replace the o-ring. |
q | Remove and install with spanner -U-40080- |
16 - | Activated charcoal filter solenoid valve 1 -N80- |
q | Checking → Vehicle diagnosis, testing and information system VAS 5051, Final control diagnosis |
q | Activated charcoal filter system: → Chapter |