Caution | When doing any repair work, especially in the engine bay, due to the cramped conditions, pay attention to the following: |
| Route all sorts of pipes (e.g. for fuel, hydraulics, activated charcoal filter system, coolant, refrigerant, brake fluid and vacuum pipes and hoses) and electrical wiring so that the original positions are restored. |
| Ensure sufficient clearance from all moving or hot components. |
|
Caution | Fuel system is under pressure! Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection. |
|
| To prevent injuries to persons and/or damage to the injection and ignition system, the following must be observed: |
| t
| Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed. |
| t
| The ignition must be switched off before connecting or disconnecting injection or ignition system wiring or tester cables. |
| t
| If the engine is to be turned at starter speed, without starting: |
|
|
|
