–
| Connect the hose -1- of the collector bottle -SAT 1175B/1- to the bleeder screws of the brake calliper on the front axle. |
–
| Open the bleeding bolts. |
–
| Leave the bleeding bolts open and only close when brake liquid appears without any air bubbles. |
–
| Remove the hose of the collector bottle -SAT 1175B/1- and place a protective cap on a bleeding bolt of the brake calliper. |
–
| Tighten the bleeding bolts to the specified tightening torque. See → Chapter |
–
| After carrying out the operations described above, bleed the brake calliper / cylinder of the rear axle. |
–
| Bleed the control unit of the brake system using the vehicle diagnostic, testing and information system -VAS 505X - according to the instructions in chapter → Chapter. |
–
| After ending the procedure using the vehicle diagnostic, testing and information system -VAS 505X -, switch off the ignition and disconnect the diagnostic connector. |
–
| Continue according to the instructions of section → Chapter. |
|
|
|