SEAT Workshop Service and Repair Manuals

Removing and installing anti-roll bar Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331-, see equivalent → Anchor. Removal: –  Remove noise insulation.

–  Unscrew bolt -4-.

–  Unscrew hexagon nuts -2-. –  Remove the stabiliser together with the bar. Take apart if a replacement should be necessary. Installation   Note t  If renewing the anti-roll bar, check the suspension version fitted on the vehicle. t  Grease should not be present on stabiliser and bearings.

–  Fit new nuts -2-, but do not tighten yet.

–  Tighten the new bolt-4- to the specified torque → Item.

–  Tighten nuts -2- to 25 Nm. –  Install soundproofing. → Rep. gr.50