Tighten clamp on outer joint |
–
| Apply special pliers-V.A.G 1682- as shown in diagram. Ensure jaws of tensioner lie in corners -arrows B- of ears on O-type clip. |
–
| Tighten clamp by turning spindle with a torque wrench (do not cant pliers). |
Note t
| Given the firmness of the material (in comparison with the rubber) of the union dustguard, a stainless steel clamp is required, this can only be tightened using the pliers -V.A.G 1682-. |
t
| Tightening torque: 25 Nm |
t
| Use torque wrench -C- with adjustment range 5 … 50 Nm, (e.g. torque wrench -V.A.G 1331-). |
t
| Check that the spindle thread -A- of the pliers is easily movable; apply grease if necessary. |
t
| If the thread does not turn easily due to dirt, for example, it will not be possible to tension the clamp to the prescribed torque. |
|
|
|