Headlights with gas discharge bulbs, vehicles 06.00 ► |
Caution Before working on headlights with gas discharge bulbs, always switch off the headlights and remove the ignition key. |
Then switch dipped beam on and off again. This will eliminate any possible residual voltage. |
|
Note! t
| It is essential to first remove the complete headlight to remove or install the dipped beam gas discharge bulb and the main beam H7 bulb. |
t
| The side light bulb and the turn signal bulb can be replaced with the headlight installed. |
t
| The headlight range control with gas discharge bulbs is equipped with self-diagnosis. |
To localise faults, use vehicle diagnosis, testing and information system -VAS 5051A- in “Guided fault finding” mode. |
|
|
|