High-level brake light bulb -M25-: Removing and installing |
Note t
| Failure of LEDs in third brake light: |
t
| The individual LEDs (light-emitting diodes) for the high-level brake light come in groups of four LEDs each and are supplied with current in groups. |
t
| The high-level brake light is designed so that, in the event that a group of LEDs fail, legal requirements continue to be met. |
t
| If another group of LEDs fail, then legal requirements are no longer met. |
t
| When a group of LEDs fail, the intact LEDs are subjected to stronger loads, which implies that further groups of LEDs are likely to fail shortly. |
t
| If more than four individual LEDs on the high-level brake light are defective, the high-level brake light should be replaced (repair measure). |
|
|
|