seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Front fog lights > < Number plate light X

Leon Mk1

Removing and installing ignition switch, vehicles 06.00 ▸
Removing and installing ignition switch, vehicles 06.00 ►
  Note!
t  If the vehicle has a security-coded radio, obtain the anti-theft code from customer before disconnecting the battery.
t  When the battery is reconnected, check operation of electrical equipment (radio, clock, convenience electronics and so on) according to the workshop manual and/or the owner's manual.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove steering column switches → Chapter.
   
–  Pull multi-pin connector off ignition switch -arrow-.
–  Remove anti-tamper paint from securing screws -A-.
–  Loosen the two securing screws -A- slightly and pull ignition switch out from steering lock housing in -direction of arrow-.
Installing:
–  Push ignition switch into steering lock housing.
  Note!
When installing the ignition/starter switch ensure that the ignition/starter switch and the lock cylinder are in the same position, e.g. “ignition on”.
–  Tighten securing screws and reinstate anti-tamper paint coating.
–  Connect multi-pin connector to ignition switch.
–  Install steering column switch and steering wheel → Chapter.
  N94-0207

Front fog lights > < Number plate light X