seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Rear lights on the bodywork and tailgate: Exeo > < LED rear lights

Leon Mk1

Lamp holder on the bodywork: Removing and installing
Lamp holder on the bodywork: Removing and installing
Removal:
–  Switch off ignition and all electrical consumers and take out ignition key.
–  Turn light switch to „0“ position.
   
–  Rear lights on the bodywork: Removing → Chapter.
–  Press out of the retaining bar-arrow- and remove the bulb carrier from the rear light.
  Caution
Do not apply excessive force to the bulb holder in order not to force the wires of the LED module.
  E00-10618
The plug connector of the LED module is similar to the lamp holder.
–  Unscrew the bulb -2- for the indicator from the bulb holder -4-.
–  Separate the plug connector of the LED module -1- from the lamp holder -4-.
–  Separate the plug connector of the LED module -3- from the lamp holder -4-.
Installation
Installation is carried out in reverse order, noting the following:
–  Fit new bulbs in bulb holder; do not touch the glass part of the bulb with bare hands.
–  Switch the plug connector of the LED module.
–  Route the wiring harness of the LED module to its fitting position without interruptions.
  E94-10355

Rear lights on the bodywork and tailgate: Exeo > < LED rear lights