| –
| Fit a new bush and insert the cable ring into the selector lever -arrow-. |
| –
| Insert the selector lever cable into the gearbox bracket and secure it to the bracket in the engine bay. |
| –
| Change the selector lever position from “P” to “1”. Do it by pushing the selector lever push rod. |
| l
| The gear actioning mechanism and the selector lever cable should move freely; if necessary, replace the selector lever cable or repair the gearbox actioning mechanism. |
| –
| Adjusting the selector lever cable → Chapter. |
| –
| Fit the front heat shield. |
| –
| Fit the front bracket and tighten the bolts to 25 Nm. |
| –
| Fit the front part of the exhaust pipe with catalytic converter: → Rep. Gr.26 |
| –
| Move the selector lever to “N”. |
| –
| Fitting the selector lever position illumination connector. |
| –
| Fit the gear selector cover by pressing down until it engages. |
| –
| Fit the selector lever cover frame. |
Note! | Be careful with the edges of the frame as they are sharp and can cut. |
|
|
|
