seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Neutral overrun spring: dismounting and assembling > < Dismounting

Leon Mk2

Assembly
Assembly
Perform the operations described for the dismounting in the reverse order taking into account the following points:
–  Lubricate the axle and the bearing sleeve before their assembly using -G052 142 A2- lubricating grease.
–  Fit the clutch and brake axle up to the stop; if necessary, move the brake pedal a little to make its assembly easier, and at the same time extract the pin or the bolt used earlier.
–  Put the washer into place with its nut and tighten at the required torque.
Tightening torque: 25 Nm
–  Assemble the neutral overrun spring → Chapter.
   
–  Push the clutch pedal in the direction of the -arrow- in order to fit it into the housing over the pedal, make sure that it has been fitted into place properly.
  Note!
The housing -A- must be over the working bar -B- of the clutch pump.
  V30-0419

Neutral overrun spring: dismounting and assembling > < Dismounting