seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Mechanism and working cables: dismounting and assembling; assembly chart > < Handle and cover of the gear stick: dismounting and assembling

Leon Mk2

Gear stick and protective box: repair
   
Gear stick and protective box: repair
  Note!
Lubricate the support points and the slide surfaces with grease -G 052 142 A2-.
1 - Safety washer
q   Dismount and assemble → Fig.
2 - Sleeve
3 - Compression spring
4 - Sleeve
5 - Torx Bolt, 5 Nm
6 - Top
7 - Half bearing
8 - Shock absorber
9 - Gear stick guide
10 - Shock absorber washer
11 - Seal
q   Between the protective box and the body
q   Self-adhesive
q   Stick it onto the protective box
12 - Gear stick
13 - Plastic nut
q   For attaching the console to the protective box.
14 - Shock absorber
15 - Protective box for the gear stick
16 - Bearing sleeve
17 - Bolt, 25 Nm
18 - Shaft
19 - Guide sleeve
20 - Compression spring
q   Assembly → Fig.
21 - Selection bracket
22 - Bolt Torx, 5 Nm
23 - Lower plate
q   In order to dismount it, open the flanges
24 - Safety washer
25 - Cable for changing gears
q   Fit the selection bracket into place
q   Position for assembly → Chapter
26 - Cable for changing gears
27 - Bearing sleeve
q   It fits into a single position
28 - Safety washer

   
Dismounting and assembling the safety washer
–  For dismounting and assembling the safety washer, pull the gear stick in the direction of the arrow -A- and at the same time press downwards until reaching the stopper for the separating sleeve with a screwdriver in the direction of the arrow -B -.
  Note!
Do not tilt the separating sleeve when pressing it down. It must be able to easily access the slot for housing the safety washer in the gear stick.
  V34-2958
Assembly of the compression spring
–  Put the spring into place in such a way that the part -A- will remain under the pivot -arrow-.
–  Then pull back the part B towards the gear stick until it stays on the upper part of the pin -arrow-.
  E34-0146

Mechanism and working cables: dismounting and assembling; assembly chart > < Handle and cover of the gear stick: dismounting and assembling