seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gear drive mechanism: repairing > < Mechanism for working the gearbox: adjust

Leon Mk2

Checking the functioning of the mechanism for working the gearbox
Checking the functioning of the mechanism for working the gearbox
The gear stick must be in the position for neutral, in the track for 3rd / 4th gear. The lower part of the gear stick must be in an upright position.
–  Work the clutch pedal: Connect and disconnect all the gears several times, make sure especially that the reverse gear connection works properly.
  Note!
If, when putting a gear into position several times it still sticks, you must check the selector lever unit in the following manner:
–  Engage the first gear.
–  Move the gear stick to the left up to the end and then release it again.
–  At the same time, the switch axle for the gear box must be examined (2nd mechanic).
   
–  When moving the gear stick, it must perform a run of approximately 1 mm. Direction of the -arrow-.
–  If, when engaging a gear over and over again, there are still blocks or interferences, or should the run of the gear stick not be the right one, perform the adjustment again for the mechanism for working the gear box → Chapter.
  N34-0885

Gear drive mechanism: repairing > < Mechanism for working the gearbox: adjust