Leon Mk2
| Input shaft: assembly overview |
Note| t | When new gears are being fitted, the technical data must be consulted → Chapter, Identification letters, group allocation, ratios, filling quantities |
| t | The input shaft must be always adjusted whenever elements have been replaced which could affect the position of the roller bearings. Refer to Adjustment chart → Chapter |
| 1 - | clutch housing |
| q | Repairing → Chapter |
| 2 - | Outer track, roller bearing |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 3 - | Tapered roller bearing |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 4 - | Input shaft: |
| q | Adjusting → Chapter |
| 5 - | 3rd gear pinion |
| q | Removing → Fig. |
| q | Installing → Fig. |
| q | Fitting position: the collar must be facing the gear pinion for 4th gear |
| 6 - | Circlip |
| q | Use pliers -A 81124- to remove the safety ring. |
| q | Always replace |
| 7 - | 4th gear wheel |
| q | Removing → Fig. |
| q | Installing → Fig. |
| q | Fitting position: the collar must be facing the gear pinion for 3rd gear |
| 8 - | Tapered roller bearing |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 9 - | Thrust washer |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 10 - | Outer track, roller bearing |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 11 - | Shim |
| q | For input shaft |
| q | Determining thickness → |
| 12 - | Gearbox |
| q | Repairing → Chapter |
| 13 - | Needle bearing bush |
| q | Removing → Fig. |
| q | Before installing, insert the thrust washer → Item |
| q | Installing → Fig. |
| 14 - | Needle bearing |
| 15 - | 5th gear mobile pinion |
| q | Remove with synchromesh assembly of 5th gear → Chapter |
| 16 - | Synchromesh ring of 5th gear: |
| q | Check for wear → |
| 17 - | Spring |
| q | Installing → Fig. |
| 18 - | Locking keyways |
| q | Installing → Fig. |
| 19 - | Synchromesh hub |
| q | Installing → Fig. |
| 20 - | Mobile sleeve of 5th gear |
| q | Installing → Fig. |
| 21 - | Dished washer |
| q | Fitting position: the concave side should be facing the gear pinion for 5th gear → |
| 22 - | Attachment bolt of 5th gear mesh |
| q | 80 Nm |
| q | The screw head incorporates a housing for the plate spring → Item |
| q | Installing → Anchor |
