SEAT Workshop Service and Repair Manuals > Leon Mk2 > 02T 5-speed manual gearbox | Gearbox mechanics,operation, construction,diff. | Gearbox casing and clutch housing: repairs | Gearbox casing and clutch housing: repairs

Gearbox casing and clutch housing: repairs

Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Push rod -T20130-, see equivalent → Anchor

t	Hose clamp -T20133-, see equivalent → Anchor

t	Push rod -T20135-, see equivalent → Anchor

t	Extractor kit -U 40100B-, see equivalent → Anchor

t	Kit (case) -U-40200A-, see equivalent → Anchor

t	Kit (case) -U-40300-, see equivalent → Anchor

Insert the input shaft seal so it is flush

Remove the sleeve for the flanged shaft seal

Insert the sleeve for the flanged shaft seal

–	Use the fitting tool -T20133- screwing in the spindle of the fitting equipment onto the threaded part of the differential.

–	Rotate the nut -A- until the bush is inserted all the way using the fitting tool -T20133-.

Note

With the gearbox apart, press the bush to the limit using the adapter -U-40200/14-.

Remove the selector shaft bush -A-

–	For fitting, insert the bush by the selector shaft cover zone using the tool -T20135- on the side -1-.

Replacement: Always when the gearbox is disassembled.

SEAT Workshop Service and Repair Manuals