seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Multi-function switch F125 : fitting > < Multi-function switch F125

Leon Mk2

Multi-function switchF125: removing
Multi-function switch -F125-: removing
–  Put the gear selector lever into position “N”.
–  Switch off ignition.
–  Do not open the coolant circuit.
   
–  Press the selector lever cable locking tabs -3- and remove the cable from the counter support by lifting upwards.
–  Detach the selector lever cable -1- from the selector rod by hand.
–  Do not bend or twist the selector lever cable.
–  Disconnect the connection of the multi-function switch -F125-.
  N37-10083
–  Unscrew nut -1-.
–  Remove the elastic ring -2- and the selector rod -3- from the selector shaft -4-.
  N38-10001
–  Using a screwdriver, fold back the tabs of the securing ring -2-.
–  Replace the securing ring if the tabs are broken.
–  Unscrew nut -1-.
–  Unscrew bolt -5-.
–  Remove the multifunction switch -4- with the washers -2- and -3- from the selector shaft -6-.
  N38-10002

Multi-function switch F125 : fitting > < Multi-function switch F125