seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Cable harness for solenoid valves and senders: removing and installing > < Cable harness with 14 terminal connector removing and installing

Leon Mk2

8 terminal cable harness and Gearbox oil temperature senderG93 integrated removing and installing
   
8 terminal cable harness and Gearbox oil temperature sender -G93- integrated removing and installing
A - 8 pin connector
B - Cable harness to 8 pin connector
q   Components on the cable harness → Chapter

  Note
t  Cleaning norms when working on automatic gearbox → Chapter.
t  General repair instructions → Chapter.
Cable harness with 8 terminal connector removing
  WARNING
Take all measures concerning the disconnection of the battery → Electrical system; Rep. Gr.27.
–  With ignition switched off, disconnect earth wire at battery .
–  Remove oil sump → Chapter.
–  Remove the oil strainer → Chapter.
–  Remove the selection unit → Chapter.
   
If the gearbox is in place:
  A37-0569
–  Disconnect the 8 pin connector -B- from the gearbox connector.
–  Unscrew the attachment bolt from the 8 pin connector on the outer part of the gearbox housing.
–  With due care, take out the connector along with the cable harness -C- from the gearbox housing.
Cable harness with 8 terminal connector fitting
Installation is carried out in reverse order, noting the following:
–  Replace the O-ring on the connector.
–  Moisten the O-ring with ATF.
–  Press in the connector with the O-ring on the gearbox as far as possible.
Tightening torque
  A38-0106
ComponentNm
Securing bolt for the 8 terminal connector5,5

   

Cable harness for solenoid valves and senders: removing and installing > < Cable harness with 14 terminal connector removing and installing