Leon Mk2
Pedal mechanism, clutch pump - Assembly overview |
1 - | Securing panel |
q | Attachment for the master cylinder and the clutch pedal mount |
2 - | Seal |
q | Always replace. |
3 - | Support stand |
q | For housing the clutch pedal |
4 - | Bolt |
5 - | Mounting rack for pedal work |
q | For accommodation of the brake and accelerator pedals |
6 - | -25 Nm self-locking hexagonal nut |
q | Always replace. |
7 - | Clutch pedal switch |
q | Press the clutch pedal down for removal and fitting of the switch |
q | For removal, rotate it 90º to the left and remove it from its allotment |
q | Fit the clutch pedal switch into mount and turn 90º to right. |
8 - | Separation cap |
9 - | Bearing bush |
10 - | Clutch pedal |
q | removing and fitting → Chapter |
11 - | Mounting |
q | Removing and installing |
12 - | 25 Nm self-locking hexagonal nuts |
q | Always replace. |
13 - | Clutch master cylinder |
q | Removing and installing |
14 - | Flexible hose |
15 - | Over-centre spring |
q | removing and fitting → Chapter |
16 - | Over-centre spring seat |
q | Install in pedal bracket |
17 - | Bolt |
q | To secure the clutch pedal stop on the pedal bracket |
18 - | Clutch pedal stop |
19 - | -25 Nm self-locking hexagonal nut |
q | Always replace. |