seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing clutch pedal|Installation > < Removing and installing clutch pedal

Leon Mk2

Removal:
Removal:
–  Removing the support stand → Chapter.
–  Move pedal to highest position. Take care that over-centre spring does not jump out of neutral.
  Note
When the securing bolt is removed from the clutch pedal, take the precaution of lightly holding the clutch pedal so that it does not jump out of neutral.
   
–  Disconnect clutch pedal -1- from the assembly support holder -3- . To do so the nut -2- must be unscrewed, the clutch pedal must be slightly pressed, the screw -5- must be loosened and at the same time the over centre spring -4- must be removed.
  A30-0125
–  Clutch pedal is held by safety clip-arrow- onto master cylinder actuating rod.
  E30-10013
–  With bolt -arrow- removed, release clutch pedal from rod with pliers - T20059B -.
  Note
  E30-10001
The points of the pliers -T20059B- have been prepared to the specified dimensions: left hand side 7.5 mm and right hand side 3.5 mm.
–  Remove clutch pedal.
  E30-10011

Removing and installing clutch pedal|Installation > < Removing and installing clutch pedal