seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clutch housing: removing and fitting|Installation > < Clutch housing: removing and fitting

Leon Mk2

Removal:
Removal:
–  Remove gearbox → Chapter.
–  Mount gearbox on assembly stand → Chapter.
–  Fit tray -T20173- beneath gearbox.
–  Drain gear oil.
   
–  Remove securing spring -arrow- on clutch release lever.
–  Unscrew bolts -1- and -2-.
–  Remove clutch release lever with clutch release collar and guide sleeve.
  A30-0108
–  Unscrew securing bolt of right flanged shaft arrow. To do this, screw two bolts into flange and immobilise shaft with a lever.
–  Unscrew the flanged shaft with the compression spring, thrust washer and conical ring.
–  Turn gearbox in support bracket so that clutch housing is upwards.
  A34-0615
–  Unscrew the 18 clutch housing attachment bolts -arrow-
  Note
Do not tilt the clutch housing to prevent damage to the roller bearings or their seating in the input and lay shafts.
–  Remove clutch housing, if necessary carefully levering up all around along protruding housing flange and alternating between sides, being careful not to damage sealing surfaces.
  A34-0619

Clutch housing: removing and fitting|Installation > < Clutch housing: removing and fitting