SEAT Workshop Service and Repair Manuals > Leon Mk2 > 0AJ 6-speed manual gearbox | Clutch, control | Clutch action | Removing and installing over-centre spring

Installation

Installation is carried out in the reverse sequence; note the following:

Grease all bearing bushes and contact surfaces, according to → Spare parts catalogue.

–	Position clutch pedal over-centre spring -4- in the mounting bracket -3-, at the same time lightly pressing upper part of clutch pedal -1- towards master cylinder and against neutral over-centre spring, until bolt -5- can pass through and tighten nut -2- firmly.

–	Install clutch pedal mounting bracket → Chapter.

–	Bleed air from hydraulic clutch system → Chapter

SEAT Workshop Service and Repair Manuals