Leon Mk2
| Selector lever cable (counterhold of the and relay lever made of plastic): Assembly overview |
Note| t | Lubricate bearing positions and sliding surfaces. |
| t | Allocate grease using → Electronic parts catalogue (ETKA). |
| t | Do not kink selector cables. |
| 1 - | Selector shaft with selector shaft cover |
| 2 - | Runner |
| 3 - | Return lever |
| q | Made of plastic |
| q | For correct version, refer to → Electronic spare parts catalogue |
| q | Installation position → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| q | Remove and fit the idler rod together with the cable fastener → Chapter |
| 4 - | Cable attachment |
| q | After installing, adjust selector mechanism → Chapter |
| q | To secure selection control cable to idler rod |
| q | Do not mix up. The element fastening the cable selector to the idler rod and fastening the connector cable to the selector rod are different. |
| q | Detaching plastic relay lever → Chapter |
| q | Pressing on plastic relay lever → Chapter |
| q | Allocation → Fig. |
| 5 - | Gearbox selector lever |
| q | Installing → Fig. |
| q | Installation position → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| 6 - | Conical hexagon bolt |
| q | → Item |
| 7 - | Cable attachment |
| q | After installing, adjust selector mechanism → Chapter |
| q | Secures gear selector cable to gearbox selector lever |
| q | Do not mix up. The element fastening the cable selector to the idler rod and fastening the connector cable to the selector rod are different. |
| q | Allocation → Fig. |
| 8 - | Retainer washer |
| q | Always replace. |
| 9 - | Retainer washer |
| q | Always replace. |
| q | Take care not to damage selector cables when removing. |
| 10 - | Gear selector cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| 11 - | Lever protection box |
| 12 - | Retainer washer |
| q | Always replace. |
| 13 - | Selection control cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| 14 - | Retainer washer |
| q | Always replace. |
| q | Take care not to damage selector cables when removing. |
| 15 - | Cable support bracket |
| q | Made of plastic |
| 16 - | Hexagon bolt, 20 Nm |
| q | 3 off |
| q | For cable support bracket |
| 17 - | Grommet |
| q | 3 off |
| q | Cable support bracket mounting on gearbox |
| 18 - | Spacer |
| q | 3 off |
| 19 - | Seal |
| q | replace → Item |
| 20 - | Wiring clip |
| q | ⇒ Relay lever with wiring clip → Fig. |
|
|
