| Determining fitting position of shaft bevel gear (actual values) |
| This work should only be performed if dimension “r” is not given on bevel gear with stub shaft and parts are to be renewed which directly affect the installation position of the shaft bevel gear. |
| These are both taper roller bearings for shaft bevel gear, pinion housing and rear axle housing. |
| –
| Remove bevel gear with stub shaft and differential. |
| –
| Set up universal measuring mandrel as shown from → Anchor, insert in rear axle housing and measure difference to “Ro” (maximum deflection (return point), reading off number in red range). The measured value corresponds to dimension “r”. Note reading. |
| –
| After renewing parts, adjust shaft bevel gear as described from → Chapter. When doing this, use determined dimension “r” when determining shim "S3". |
|
|
|
