seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing oil seal for left flange shaft > < Renewing oil seal for left flange shaft

Leon Mk2

Removing oil seal for left flange shaft
Removing oil seal for left flange shaft
–  Raise vehicle until weight is taken off front axle.
   
–  Unscrew bolt for drive shaft/wheel hub -arrow- and wheel bolts for left wheel.
–  Raise vehicle.
–  Remove left wheel.
–  Remove noise insulation tray.
  N37-0095
–  Separate -arrow- left coupling rod from anti-roll bar.
  N40-0099
–  Separate left threaded connection -arrow- between wheel bearing housing and lower swivel joint.
–  Turn steering to left full lock and press drive shaft out of wheel bearing housing → Running gear, axles, steering - front and four-wheel drive; Rep. Gr.40.
–  Remove left drive shaft.
–  Remove flange shaft securing bolts by screwing two bolts into flange and counterholding flange shaft with a lever.
–  Place drip tray under gearbox.
–  Carefully remove stub shaft with compression spring. Taper ring, thrust washer and compression spring can drop out.
  N40-0118
–  Pull out flange shaft oil seal using -VW 771- and -VW 771/37-.
  N39-0852

Installing oil seal for left flange shaft > < Renewing oil seal for left flange shaft