Leon Mk2
| Adjustment chart |
Note| If repairs have been carried out to the gearbox, it is only necessary to adjust the pinion shaft, crown wheel or final drive set if components have been renewed which have a direct effect on the adjustment of the final drive. Refer to the following table to avoid unnecessary adjustment work: |
| To be adjusted: | Crown | Pinion shaft | Pinion shaft | Backlash |
| („S1“ + „S2“) | („S3“ + „S4“) via allowance „r“ | Shim „S4“ only | 0,12 - 0,28 | |
| → Chapter | → Chapter | → Chapter | → Chapter | |
| Component renewed | ||||
| Gearbox housing → Remark | X | X | X | |
| Bearing housing | X | X | ||
| Differential casing | X | X | ||
| Taper roller bearings for pinion shaft | X | X | ||
| Tapered roller bearings for differential | X | X | ||
| Final drive gear set → Remark | X | X | ||
| Wheel drive shaft gear cover | X | X |
| 1) | Pinion shaft and crown wheel; only renew together. |
| 2) | If the gearbox housing is renewed the input shaft must also be adjusted → Chapter. |
