Leon Mk2
| Gear selection mechanism:installation overview |
| Part I: |
Note| Lubricate the support points and contact surfaces with polyurea grease. Allocation: → Spare parts catalogue. |
| 1 - | Ball |
| 2 - | Washer |
| 3 - | Frame |
| 4 - | Washer |
| 5 - | Plate |
| q | Lip points towards ball guide → Item |
| 6 - | Circlip |
| q | Take out before removing ball |
| 7 - | Compression spring |
| 8 - | Spacer bush |
| 9 - | Plate |
| 10 - | Circlip |
| 11 - | soundproofing |
| q | -Arrow- marked on soundproofing points in direction of travel |
| 12 - | Gear lever knob |
| q | With boot |
| q | removing and fitting → Chapter |
| 13 - | Nut, 10 Nm |
| 14 - | Gear lever bearing |
| 15 - | Torx socket head bolt |
| 16 - | Gear lever |
| q | Angled section points toward rear |
| 17 - | Bolt. |
| 18 - | Nut, 10 Nm |
| 19 - | Gear lever casing |
| 20 - | For selector rod/gear lever |
| 21 - | Nut, 10 Nm |
| q | Self-locking |
| q | replace |
| 22 - | Thrust piece |
| Part II: |
Note| Lubricate the support points and contact surfaces with polyurea grease. Allocation: → Spare parts catalogue. |
| 1 - | Bellows |
| q | Secure to selector rod with commercially available instant adhesive |
| 2 - | Plate |
| 3 - | Joint shoe |
| q | To remove, bend open preened points on selector rod → Item. |
| 4 - | Cap nut, 23 Nm |
| 5 - | Ball head bolts |
| 6 - | Joint shoe |
| q | Remove circlips → Item to remove |
| 7 - | Connecting rod |
| q | Remove circlips → Item to remove |
| 8 - | Thrust piece |
| 9 - | Thrust piece |
| 10 - | Bolt, 23 Nm |
| 11 - | Sleeve |
| 12 - | Securing clip |
| 13 - | Bolt, 40 Nm |
| 14 - | Push rod |
| q | With bush, bolt and washers |
| 15 - | Hexagon socket head bolt, 23 Nm |
| 16 - | Plate |
| 17 - | Gear lever bearing |
| 18 - | Clamping ring for bellows |
| 19 - | Bellows |
| q | To remove, carefully pull bellows over selector rod → Item and push rod → Item. |
| q | When installing, align with markings on selector rod → Item and push rod → Item. |
| 20 - | Hexagon socket head bolt, 23 Nm |
| 21 - | Clamp |
| 22 - | Selector rod |
| 23 - | For selector rod/gear lever |
| 24 - | Cap nut, 10 Nm |
| q | Self-locking |
| q | replace |
| 25 - | Selector shaft lever |
