Leon Mk2
| Repairing selector lever and selector lever housing |
Note!| Lubricate all bearings and contact surfaces with grease -G 000 450 02-. |
| 1 - | Securing clip |
| q | Removing and installing → Fig. |
| 2 - | Bush |
| 3 - | Compression spring |
| 4 - | Bush |
| q | Installation position: narrow shoulder faces upwards |
| 5 - | Torx screw, 5 Nm |
| 6 - | Cover |
| 7 - | Damping |
| 8 - | Ball socket |
| 9 - | Selector lever guide |
| 10 - | Damping washer |
| 11 - | Securing clip |
| 12 - | Bearing bush |
| q | Fits in one position only |
| 13 - | Selector lever |
| 14 - | Damping |
| 15 - | Selector lever housing |
| 16 - | Bearing bush |
| 17 - | Pivot pin |
| 18 - | Guide bush |
| 19 - | Compression spring |
| q | Installing → Fig. |
| 20 - | Gate selector lever |
| 21 - | Torx screw, 5 Nm |
| 22 - | Bolt |
| q | Screw into selector lever housing |
| 23 - | Base plate |
| q | With bonded seal |
| q | Installation position: curved edge -arrow- faces handbrake lever |
| 24 - | Floor pan |
| 25 - | Hexagon nut, 10 Nm |
| q | Self-locking |
| q | Always renew |
| 26 - | Securing clip |
| 27 - | Gear selector cable |
| q | Press onto selector lever guide |
| q | Installation position → Chapter |
| 28 - | Gate selector cable |
| q | On gate selector lever |
| q | Installation position → Chapter |
| 29 - | Securing clip |
|
|
