seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Adjusting selector mechanism, gearboxes with angled rod (from gearbox date 13?01?3) > < Adjusting selector mechanism, gearbox with retaining pin (through gearbox date 12?01?3)

Leon Mk2

Functional check
Functional check
l  With gearbox in neutral, selector lever must rest in gate for 3rd and 4th gear.
–  Operate clutch.
–  Select all gears several times. Pay particular attention to operation of reverse gear lock.
Should a gear fail to engage smoothly after repeated selection, then check as follows:
Now set selector lever as follows:
–  Select neutral using selector lever.
   
–  Guide locking pin -T10027- or locking pin -T10027 A- through hole -A- into hole -B-.
  N34-0882
l  The selector shaft must have moved downwards -direction of arrow 1-.
–  If selector mechanism is adjusted properly, it must be possible to push retaining pin -A- into gearbox -direction of arrow-.
The selector shaft is then secured.
–  If this is not the case, adjust selector mechanism → Chapter.
  N34-1088

Adjusting selector mechanism, gearboxes with angled rod (from gearbox date 13?01?3) > < Adjusting selector mechanism, gearbox with retaining pin (through gearbox date 12?01?3)