Leon Mk2
| Assembly overview - removing and installing selector cables |
Note!| Lubricate bearing positions and sliding surfaces with grease -G 000 450 02-. |
| 1 - | Selector lever housing |
| 2 - | Securing clip |
| q | Do not damage cables when removing |
| 3 - | Securing clip |
| 4 - | Gear selector cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| q | Cables cannot be separated from each other |
| q | Always remove and install together → Chapter |
| 5 - | Gate selector cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| q | Cables cannot be separated from each other |
| q | Always remove and install together → Chapter |
| 6 - | Self-locking hexagon flange nut, 5 Nm |
| q | For securing retaining plate to floor pan |
| q | Always renew |
| 7 - | Retaining plate |
| q | With seal |
| q | Attached to floor pan |
| q | Ensure proper seating of seal under floor pan |
| 8 - | Hexagon bolt, 20 Nm |
| q | For support bracket |
| 9 - | Support bracket |
| q | Secured to gearbox |
| 10 - | Grommet |
| q | Support bracket mounting on gearbox |
| 11 - | Spacer |
| q | Support bracket mounting on gearbox |
| 12 - | Cable end-piece |
| q | For gate selector cable to relay lever |
| q | Renew after removing from relay lever → Item |
| q | From11.02 with end-to-end holes. |
| q | From this date, not necessary renew. |
| q | Secured with securing clip → Fig.. |
| q | Allocation → Fig. |
| q | Removing and installing → Chapter |
| 13 - | Relay lever |
| q | Installation position → Chapter |
| q | After installing, adjust selector mechanism → Chapter |
| q | From11.02 cable end-piece adapted with end-to-end hole |
| 14 - | Bearing bush |
| 15 - | Securing clip |
| q | Removing and installing → Chapter |
| 16 - | Shoe |
| q | Grease lightly before installing |
| 17 - | Gearbox selector lever |
| q | With damper weight |
| q | Installation position → Chapter |
| q | Install so that master spline aligns with selector shaft |
| q | After installing, adjust selector mechanism → Chapter |
| q | From11.02 cable end-piece adapted with end-to-end hole |
| 18 - | Self-locking hexagon nut, 20 Nm |
| q | Always renew |
| 19 - | Cable end-piece |
| q | For gear selector cable to selector lever |
| q | Renew after removing from gearbox selector lever → Item |
| q | From11.02 with end-to-end holes. |
| q | From this date, not necessary renew. |
| q | Secured with securing clip → Fig.. |
| q | Allocation → Fig. |
| q | Removing and installing → Chapter |
|
|
