Leon Mk2
Input shaft, output shafts (pinion shafts), differential gear, bevel box and shift forks: Assembly overview |
1 - | Output shaft for 1st - 4th gear |
q | Dismantling and assembling and → Chapter |
q | Installation position → Fig. |
2 - | Selector rod with selector fork for 1st and 2nd gears |
q | Installation position → Fig. |
3 - | Selector rod with selector fork for 3rd and 4th gear |
q | Installation position → Fig. |
4 - | Output shaft for 5th, 6th and reverse gears |
q | Dismantling and assembling and → Chapter |
q | Installation position → Fig. |
5 - | Selector rod with selector fork for 5th and 6th gear |
q | Installation position → Fig. |
6 - | Selector fork for reverse gear |
q | Installation position → Fig. |
q | Identification → Fig. |
q | Repairing → Chapter |
7 - | Input shaft: |
q | Dismantling and assembling and → Chapter |
8 - | Reverse shaft |
q | With thrust washer. |
9 - | Thrust washer |
10 - | Vent valve |
q | Connect to slave cylinder → Item |
11 - | clutch housing |
12 - | Join ring for the input shaft |
q | Replace → Chapter |
13 - | O ring |
q | replace |
q | assemble on the cable connection |
q | Moisten with brake fluid before installing |
14 - | Slave cylinder with clutch release bearing |
15 - | 12 Nm |
q | 3 off |
q | replace |
16 - | Countersunk bolt, 33 Nm |
17 - | Bolt |
q | 40 Nm |
q | 4x |
q | Always replace. |
18 - | Bevelled gears |
q | Removing and installing with gearbox installed → Chapter |
q | Removing with gearbox removed → Anchor |
q | Installing with gearbox removed → Anchor |
19 - | Differential |
q | Dismantling and assembling and → Chapter |
|