seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gear change mechanism: removing and installing > < Attaching

Leon Mk2

Gear change mechanism: general fitting diagram
Gear change mechanism: general fitting diagram
  Note
Lubricate the support points and contact surfaces with grease → Parts catalogue.
   
1 - Base plate
q   Straighten tabs for removal
q   Replacement
2 - Seal
q   Replace if worn
3 - Gear stick
4 - O–ring
q   Replace if worn
5 - Security fastener
6 - Selector cable
q   Removing and installing → Chapter
q   Adjusting → Chapter
7 - Connection cable
q   Removing and installing → Chapter
q   Adjusting → Chapter
8 - Securing washer
9 - Guide
q   For compression spring → Item
10 - Bearing shell with damper element
11 - Cover
12 - Bush
13 - Securing washer
q   Removing and installing → Fig.
14 - Compression spring
15 - Bush
16 -  6 Nm
17 - Securing washer
18 - Bearing bush
19 - Gear lever guide
20 -  10 Nm
21 - Seal
q   Between gear lever casing and vehicle underbody
q   Self-adhesive
22 - Gear lever casing
23 - Bearing bush
24 - Bush bolts
25 - Guide sleeve
q   Fit into the gear lever housing
26 - Compression spring
q   Fitting → Fig.
27 -  5 Nm
28 - Selector bracket

   
Removing and installing securing washer
–  Secure gear lever -2-.
–  Insert the spacer sleeve -3- in the -direction of the arrow-.
–  Remove safety washer -1-.
  A34-0595
Fit compression spring
–  Attach reinforcement -A- of compression spring onto guide -1- on the upper part.
–  Move the compression spring reinforcement -B- towards the lower part and insert it into the guide -1-.
  Note
For clarity, the selector bracket is shown removed.
  A34-0601

Gear change mechanism: removing and installing > < Attaching